(pack) Rod Sealing U-ring K26 NBR 80 ID 025mm-300mm (choose dimensions)

Description

K26 is a double acting complete piston seal which consists of a steel plate vulcanized with elastomeric nitrile rubber using special production methods. The sealing lips do have springs in order to increase the preload.
PRODUCT ADVANTAGES
• Good sealing performance at low pressures due to the reason having spring on the sealing lips
• Long service life
• Ready to fit complete piston
• Also used in pneumatic systems
APPLICATION
Short stroke , low pressure hydraulic cylinder and special pneumatic cylinders.
MATERIAL
CODE
NBR
90 SHORE A
NB
9001
STEEL
ST
37
FE
9901
STAINLESS STEEL SPRING
CN
9901
OPERATING CONDITIONS
MEDIA
Mineral oils (DIN 51524)
HFA ve HFB
HFC
Compressed
Air
TEMPERATURE
-30°C +105°C
+5°C +60°C
-30°C +60°C
-30°C +105°C
PRESSURE
Diagram 1
Diagram 1
Diagram 1
SPEED
≤0.5 m/sn
≤0.5 m/sn
≤0.5 m/sn
Note: The above data are maximum values and cannot be used at the same time.
SURFACE ROUGHNESS
Ra
Rmax
Sliding Surface ØD
≤0.2 μm
≤2.0 μm
Note: It is recommended to have 50% to 90% of the working surface material contact area value.
INSTALLATION
K26 is pushed onto the piston rod with the rubber layer on the clamping flange towards the rod and fixed by fastening. The nut has to be secured. The sliding surface and the cylinder bore should be oiled with an oil that must not go into the reaction with the sealing element during the installation process. Special precautions has to be taken at the end of the stokes to avoid damaging of the sealing lips.
NOTES
For special applications that require high temperatures , K26 can be produced in FKM material.